Installation; Vm0202H Installation - ATEN HDMI VM0202H User Manual

VM0202H / VM0202HB User Manual

Installation

Installation of the VM0202H is simply a matter of plugging in the appropriate
cables.

VM0202H Installation

To install the switch, refer to the installation diagram below as you perform the
following steps:
1. (Optional) If you are using the serial control function, use an appropriate
RS-232 serial cable to connect the computer or serial controller to the
VM0202H's female RS-232 Serial Port.
2. Use a grounding wire to ground the unit by connecting one end of the wire
to the grounding terminal and the other end of the wire to a suitably
grounded object.
Note: Do not omit the step. Proper grounding helps to prevent damage to
the unit from power surges or static electricity.
3. Use HDMI cables to connect the video display devices to the HDMI
Output Ports on the back of the VM0202H.
4. Use HDMI cables to connect the video source devices to the HDMI Input
Ports on the back of the VM0202H.
5. Connect the IR Receiver to the IR Receiver Port.
6. Plug the provided power adapter into an appropriate AC power source;
plug the power adapter cable into the Power Jack on the back of the
VM0202H.
7. Power on the VM0202H, the display, and source devices.
12