Advertisement
5. Check the program numbers in the diagnostic display as follows:
a) Start with the NavPilot powered on and in the STBY display.
b) Press the MENU key.
c) Turn the Enter-knob to highlight OTHER MENU and then press the Enter-knob.
d) Turn the Enter-knob to highlight SYSTEM SETUP and then press the Enter-knob.
e) Turn the Enter-knob to highlight the selection for DIAGNOSTIC. (The default selection is
OFF).
f) Press the Enter-knob.
g) Turn the Enter-knob to highlight PROCESSOR UNIT and then press the Enter-knob.
h) Confirm that the program numbers are now updated.
i) Press the MENU key once to return to the highlighted PROCESSOR UNIT selection and then
press the Enter-knob.
j) Turn the Enter-knob to highlight CONTROL UNIT and then press the Enter-knob.
k) Confirm that the program numbers are now updated.
l) Press the MENU key 4 times to return to the STBY display.
PLEASE NOTE: You will be required to re-accomplish the initial setup of the pilot after
programming/upgrading the unit because all previous settings are overwritten.
Page 9
FURUNO U.S.A., INC.
www.furunousa.com
Camas, WA
Denton, MD
(360) 834-9300
(410) 479-4420
Advertisement
