Remote Mounting the Setback Control
Install Wire (B) – Protective Plate
Step 17: Using wire (B), insert one end into the middle terminal location on the Protective Plate. This is
shown in Figure 22.
Wire (A)
Wire (B)
Protective
Plate
Figure 22
Fasten Wire (B) into its Designated Location – Protective Plate
Step 18: Tighten the slotted screw in the middle terminal location on the Protective Plate. This is shown in
Figure 23.
Wire (A)
Wire (B)
Protective
Plate
Slotted head
screwdriver
Figure 23
-17-