Bradford White 238-47808-00A Installation And Operation Manual page 13

Fasten Wire (A) into its Designated Location – Backplate
Step 9: Tighten the slotted screw in the top terminal location on the backplate (located on the Setback
Control Junction Box Assembly). This is shown in Figure 15.
Slotted head
screwdriver
Install Wire (B) – Backplate
Step 10: Using wire (B), insert one end into the middle terminal location on the backplate (located on the
Setback Control Junction Box Assembly). This is shown in Figure 16. Be sure that the wire already
located in this location is not dislodged.
Wire (B)
Wires Already
Installed
Remote Mounting the Setback Control
Figure 15
Backplate
Wire (A)
Figure 16
-13-
Wire (A)
Setback Control
Junction Box Assembly
Backplate