Table of Contents
Advertisement
Figure 222 Successful Restoration Confirmation Screen
34.5 Uploading Firmware and Configuration Files
This section shows you how to upload firmware and configuration files. You can upload
configuration files by following the procedure in
instructions in Menu 24.7.2 - System Maintenance - Upload System Configuration File
(for console port).
Do not interrupt the file transfer process as this may PERMANENTLY
DAMAGE YOUR ZyXEL Device.
34.5.1 Firmware File Upload
FTP is the preferred method for uploading the firmware and configuration. To use this feature,
your computer must have an FTP client.
When you telnet into the ZyXEL Device, you will see the following screens for uploading
firmware and the configuration file using FTP.
Figure 223 Menu 24.7.1: System Maintenance - Upload System Firmware
To upload the system firmware, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your system.
SMT password as requested.
3. Type "put firmwarefilename ras" where "firmwarefilename" is the name
of your firmware upgrade file on your workstation and "ras" is the
remote file name on the system.
4. The system reboots automatically after a successful firmware upload.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on uploading system firmware using TFTP (note
that you must remain on this menu to upload system firmware using TFTP),
please see your manual.
34.5.2 Configuration File Upload
You see the following screen when you telnet into menu 24.7.2.
P-793H User's Guide
Chapter 34 Firmware and Configuration File Maintenance
Save to ROM
Hit any key to start system reboot.
Menu 24.7.1 - System Maintenance - Upload System Firmware
Section 34.4 on page 328
Then type "root" and
or by following the
331
Advertisement
Table of Contents
Troubleshooting
