Pptp Encapsulation; Table 4-2 Fields In Menu 11.1 (Pppoe Encapsulation Specific) - ZyXEL Communications ZyXEL ZYWALL10 User Manual

ZyWALL 10 Internet Security Gateway
Do not specify a nailed-up connection unless your telephone company offers flat-rate service or you need a
constant connection and the cost is of no concern.
The following table describes the fields not already described in Table 4-1.

Table 4-2 Fields in Menu 11.1 (PPPoE Encapsulation Specific)

FIELD
Authen
Telco Option
Allocated Budget
Period(hr)
Schedules
Nailed-Up
Connection
Session Options
Idle Timeout

4.1.3 PPTP Encapsulation

If you change the Encapsulation to PPTP in menu 11.1, then you will see the next screen. Please see the
appendices for information on PPTP.
4-4
DESCRIPTION
This field sets the authentication protocol used for
outgoing calls.
Options for this field are:
CHAP/PAP - Your ZyWALL will accept either CHAP or
PAP when requested by this remote node.
CHAP - accept CHAP only.
PAP - accept PAP only.
The field sets a ceiling for outgoing call time for this
remote node. The default for this field is 0 meaning no
budget control.
This field is the time period that the budget should be
reset. For example, if we are allowed to call this remote
node for a maximum of 10 minutes every hour, then the
Allocated Budget is (10 minutes) and the Period(hr) is
1 (hour).
You can apply up to four schedule sets here. For more
details please refer to the Call Schedule Setup chapter.
This field specifies if you want to make the connection to
this remote node a nailed-up connection. More details
are given earlier in this section.
This value specifies the idle time (i.e., the length of time
there is no traffic from the ZyWALL to the remote node)
in seconds that can elapse before the ZyWALL
automatically disconnects the PPPoE connection. This
option only applies when the ZyWALL initiates the call.
EXAMPLE
CHAP/PAP
10
1
100 seconds
(default)
Remote Node Setup