ZyXEL Communications ZyXEL ZyAIR NWA-3100 Quick Start Manual page 12

4.2 Hardware Mounting
In general, the best location for the access point is at the center of your intended wireless
coverage area. For better performance, mount the NWA-3100 high up in an area that is
free of obstructions.
Free-standing
Lie your NWA-3100 on a flat, level surface (a desk or shelf, for example) that is strong
enough to support the weight of the NWA-3100 with connection cables.
Wall-mounted
Do the following to attach your NWA-3100 to a wall.
1 Screw two screws (not included) into the wall 60mm apart (see the figure in step 3).
Use screws with 6mm ~ 8mm (0.24" ~ 0.31") wide heads. Do not screw the screws all
the way in to the wall; leave a small gap between the head of the screw and the wall.
The gap must be big enough for the screw heads to slide into the screw slots and the
connection cables to run down the back of the NWA-3100.
Make sure the screws are securely fixed to the wall and strong enough to
hold the weight of the NWA-3100 with the connection cables.
2 Adjust the cables.
Run the connection cables down the back of the NWA-3100 as shown in the following
figure.
OR:
Run the connection cables upward and along the edge of the ceiling.
ENGLISH
11