Copy/Sync Button; Reset Button - ZyXEL Communications NSA210 User Manual

Table 1 LEDs (continued)
LED COLOR
USB Green
Red
eSATA Green
Red
COPY Green
Red

1.4.1 COPY/SYNC Button

Use the COPY/SYNC button on the front panel to copy or synchronize files
between a connected USB device and the NSA. See
more details on how to configure the copy/sync settings.

1.4.2 RESET Button

Use the RESET button on the rear panel to restore the NSA's default settings.
Figure 4 The RESET Button
Press
• Press the RESET button until you hear one beep (after about two seconds),
then release it. You will hear one more beep after you release the button.
This resets the NSA's IP address and password to the default values.
NSA210 User's Guide
STATUS DESCRIPTION
On The hard disk drive is connected properly to the NSA.
Blinking The NSA is saving data to the hard disk drive.
On The hard disk drive has failed and the NSA can no longer
detect it.
Off No USB device connected to the USB port.
On The hard disk drive is connected properly to the NSA.
Blinking The NSA is saving data to the hard disk drive.
On The hard disk drive has failed and the NSA can no longer
detect it.
Off No eSATA hard disk connected to the eSATA port.
On A USB device is connected to the NSA.
Blinking The NSA is copying or synchronizing files to or from the
USB device.
On Copying or synchronizing files to or from the USB device
failed.
Off No USB device is connected.
1 Beep
Release to Reset
IP Address
Password
Chapter 1 Getting to Know Your NSA
Section 9.10 on page 196
2 Beeps
5 more seconds
Release to
Clear All Settings
for
27