Table of Contents
Advertisement
4 CONEXO RFID label
3.3 GEMÜ 6400
6
5
Item
Name
1
Optical position
indicator
2
Housing cover
3
CONEXO RFID label
(available upon
request)
4
Housing base
5
Manual override
6
Connection for manual
override
3.4 Description
GEMÜ 9468 is a motorized quarter turn actuator. The motor
is designed for DC and AC operating voltages. A manual
override and an optical position indicator are integrated as
standard. The torque in the end positions is increased. This
enables a closing curve matched to the valves.
3.5 Function
The GEMÜ 9468 motorized quarter turn actuator has a com-
pact design. The motor and gearbox are fitted in an alu-
minium housing (actuator version 4100/4200/6400) or in a
plastic housing (actuator version 2070). The quarter turn ac-
tuator is designed for use with AC or DC operating voltages
and utilises a DC motor with a secondary spur gear. The 90°
movement is achieved by a ball screw and lever based on the
scotch yoke principle. An optical position indicator and a
manual override are integrated. The end positions are ad-
justable by means of microswitches. In the end positions, the
motor is stopped immediately by a short circuit in the rotor.
The limit switches are mounted on a switch mounting plate
and are adjustable. This means that an opening and closing
limit are possible. When setting the end positions, a distance
of approx. 0.5–1 mm must be ensured in the lever of the re-
spective end positions. The power supply can be 12 V/24 V
DC, 12 V/24 V AC or 100–250 V AC, depending on the ver-
sion.
4 CONEXO RFID label
Product surface
▶ The CONEXO RFID label cannot be read out on metallic
surfaces.
GEMÜ 9468
Materials
Natural PP-R
Aluminium
Polyester (PET)
Aluminium
NOTICE
CONEXO RFID label
The CONEXO RFID label can be retrofitted on existing com-
1
ponents and can also be fitted to products from third-party
suppliers. The CONEXO RFID label must be ordered separ-
2
ately and affixed to the desired component for this purpose.
4.1 Construction
3
4
4.2 Assembly
1. Degrease the surface of the product in the area to be
covered.
2. Pull the transfer paper off the RFID label.
3. Affix the RFID label to the appropriate place on the
product.
5 Correct use
Improper use of the product
▶ Risk of severe injury or death.
▶ Manufacturer liability and guarantee will be void.
Only use the product in accordance with the operating
●
conditions specified in the contract documentation and
in this document.
The product is not intended for use in potentially explosive
areas.
6 / 26
RFID label
RFID chip
Transfer paper
DANGER
Danger of explosion
▶ Risk of death or severe injury.
Do not use the product in potentially
●
explosive zones.
WARNING
www.gemu-group.com
Advertisement
Table of Contents
