ZyXEL Communications P-2302R-P1 Support Notes page 7


If you only have one PC, connect the PC's Ethernet adapter to the ZyXEL Device's LAN port with
a crossover (red one) Ethernet cable.

If you have more than one PC, both the PC's Ethernet adapters and the ZyXEL Device's LAN port
must be connected to an external hub with straight Ethernet cable.
2. TCP/IP Installation
You must first install TCP/IP software on each PC before you can use it for Internet access. If you have already
installed TCP/IP, go to the next section to configure it; otherwise, follow these steps to install:

In the Control Panel/Network

In the Select Network Component Type

In the Select Network Protocol
TCP/IP from the
3. TCP/IP Configuration
Follow these steps to configure Windows TCP/IP:

In the Control Panel/Network
button.

In the TCP/IP
Note: Do not assign arbitrary IP address and subnet mask to your PCs, otherwise, you will not be able to access
the Internet.

Click the WINS

Click the Gateway
are none listed.

Click the DNS Configuration

Click OK to save and close the

Click OK to close the Network window. You will be prompted to insert your Windows CD or disk.
When the drivers are updated, you will be asked if you want to restart the PC. Make sure your
ZyXEL Device is powered on before answering Yes to the prompt. Repeat the above steps for
each Windows PC on your network.

Setting up the ZyXEL Device
window, click
windows, select
Network Protocols
window, click the
Properties window, select
configuration tab and select
tab. Highlight any installed gateways and click the
tab and select
TCP/IP
All contents Copyright  2007 ZyXEL Communications Corporation.
P2302R-P1 Support Notes
Add button.
windows, select Protocol
Microsoft
and click OK.
TCP/IP
obtain an IP address automatically.
Disable WINS Resolution.
Disable DNS.
properties window
and click Add.
from the manufacturers, then select
entry to select it and click
Remove button until there
Properties
7