Advertisement
make sure to remove bits of lint from the claw. In addition, be sure to apply patting powder
(lubricant) to the separation claw after cleaning the claw and when replacing the claw or drum.
*4 Drum
Refer to section "3.2 Inspection and Cleaning OPC Drum" in the service handbook
*5 Air filter
If the air filter is dirty, replace it.
*6 Charger wire and case
Clean the inner surface of the charger case and the charger wire with a cloth which should be
soaked in water and then squeezed tightly.
*7 Grid
Remove the grid from the main charger. Clean the grid with a pad (service part) moistened with
water.
*8 Developer material
After replacing the developer material, be sure to adjust the corresponding auto-toner sensor – look
in the service handbook.
*9 Front shield
Clean it with a cloth which should be soaked in water and then squeezed tightly.
*10 Heat roller -
Refer to section "3.5 Checking and Cleaning Upper and Lower Heater roller of the
service handbook.
*11 Pressure roller -
Refer to section "3.5 Checking and Cleaning Upper and Lower Heater roller of the
service handbook.
*12 Cleaning felt roller - Refer to section "3.4 Checking and Replacing Cleaning Felt Roller" of
Service Handbook.
*13 Scraper
If the tip of any of the scraper claws is chipped, replace it regardless of the number of copies made
so far. If toner adhering to the scraper claw is forcibly scraped off, it may be damaged. Therefore, if
the tip of the claw is heavily coated with toner, replace the claw.
*14 Heat roller cleaning blade
Refer to section "3.6 Checking and Cleaning Heat Roller Cleaning Blade" of this Service Handbook.
*16 Apply white grease to the main motor drive unit gears (shown arrow). See figure 4.
Advertisement
