Delay; Reverb - Zoom G2 Operation Manual

Effect Types and Parameters
TE
tE
TAPE ECHO
This effect simulates a tape echo.
1 – 99,
TIME FEEDBACK
1.0 – 2.0
Adjusts the delay time. In the range
TAP
from 10 – 990 ms, the adjustment is
made in 10-ms steps (1 – 99). For 1
Adjusts the feedback amount.
second and above, the adjustment is
made in 100-ms steps (1.0 – 2.0).
DD
dd DYNAMIC DELAY
This is a dynamic delay where the effect volume changes depending on the input signal level. With positive
settings, the effect volume increases at higher input signal levels. With negative settings, the effect volume
increases at lower input signal levels.
1 – 99,
TIME AMOUNT
1.0 – 2.0
Adjusts the delay time. In the range
TAP
from 10 – 990 ms, the adjustment is
Adjusts the level of the effect
made in 10-ms steps (1 – 99). For 1
sound mixed to the original sound
second and above, the adjustment is
made in 100-ms steps (1.0 – 2.0).
DF
dF
DYNAMIC FLANGER
This is a dynamic flanger where the effect volume changes depending on the input signal level. With positive
settings, the effect volume increases at higher input signal levels. With negative settings, the effect volume
increases at lower input signal levels.
DEPTH RATE
0 – 98, 1.0
Adjusts the modulation depth.
TAP
MP
MP
MONO PITCH SHIFTER
This is a monophonic pitch shifter with low sound modulation, suitable for single-note playing.
-12 – -1, dt,
SHIFT TONE
1 – 12, 24
Adjusts the pitch shift amount in
semitones. Selecting "dt" gives a Adjusts the sound quality.
detuning effect.
HP
HP
HARMONIZED PITCH SHIFTER
This is an intelligent pitch shifter that automatically generates harmonies according to a preset key and
scale.
-6, -5, -4, -3,
SCALE KEY
-m, m, 3, 4, 5, 6
Determines the interval for the pitch Determines the tonic for the scale used
shifted sound (see Table 2). for pitch shifting (see Table 3).
Table 2
Setting Type of scale Interval Setting Type of scale
Sixth down
-6 3
Fifth down
-5 4
Major scale Major scale
-4 Fourth down 5
Third down
-3 6
Third down
-m
Minor scale
m Third up
28
MIX
0 – 98, 1.0 0 – 98, 1.0
Adjusts the level of the effect
sound mixed to the original
sound.
SENSE
0 – 10 -10 – -1, 1 – 10
Adjusts the effect sensitivity.
SENSE
0 – 50 -10 – -1, 1 – 10
Adjusts the modulation rate.
Adjusts the effect sensitivity.
MIX
0 – 10 0 – 98, 1.0
Adjusts the level of the effect sound
mixed to the original sound.
MIX
C, Co, d...b 0 – 98, 1.0
Adjusts the level of the effect sound
mixed to the original sound.
Table 3
Interval Setting Tonic Setting Tonic
Third up C
C Fo
Fourth up C#
Co G
Fifth up d D Go
Sixth up D#
do A
E
E Ao
F F b
DL
dL
This is a delay with a maximum setting of 5000 ms.
HOLD
PD
Pd
HOLD This is a ping-pong type delay where the delay sound alternates between left and right.
EC
EC
This is a warm sounding long delay of up to 5000 ms duration.
HOLD
These three effect types have the same parameters.
TIME
Adjusts the delay time. In the
TAP
range from 10 – 990 ms, the
adjustment is made in 10-ms
steps (1 – 99). For 1 second and
above, the adjustment is made in
100-ms steps (1.0 – 5.0).
HL
HL
This reverb simulates the acoustics of a concert hall.
RM
rM
This reverb simulates the acoustics of a room.
SP
SP
This effect simulates a spring-type reverb.
The above three effect types have the same parameters.
DECAY
Adjusts the duration of the reverb.
ER
Er
This effect isolates only the early reflection components of the reverb.
DECAY
Adjusts the duration of the reverb.
MD
Md
F#
This effect produces several delay components with different delay times.
G
G#
TIME
A
Adjusts the delay time. In the
TAP
A#
range from 10 – 990 ms, the
B
adjustment is made in 10-ms
steps (1 – 99). For 1 second and
above, the adjustment is made in
100-ms steps (1.0 – 3.0).
ZOOM G2 ZOOM G2

DELAY

DELAY module
This is a delay module which allows long delay times and use of the hold function.
DELAY
PINGPONG DELAY
ECHO
1 – 99,
FEEDBACK
0 – 98, 1.0
1.0 – 5.0
Adjusts the feedback amount.

REVERB

REVERB module
This module comprises various reverb functions such as hall reverb, early reflection, and
multi-tap delay.
HALL
ROOM
SPRING
TONE
1 – 30 0 – 10
Adjusts the sound quality.
EARLY REFLECTION
SHAPE
1 – 30 ±10
Adjusts the envelope of the effect sound.
In the negative range, the envelope is
reversed. At 0, the effect is a gate reverb.
In the positive range, the envelope is a
decay-type envelope.
MULTI TAP DELAY
1 – 99,
PATTERN
1 – 8
1.0 – 3.0
Selects the combination pattern for the
taps. The selection ranges from
rhythmical to random patterns.
Effect Types and Parameters
MIX
0 – 98, 1.0
Adjusts the level of the effect
sound mixed to the original
sound.
MIX
0 – 98, 1.0
Adjusts the level of the effect sound
mixed to the original sound.
MIX
0 – 98, 1.0
Adjusts the mixing ratio of
original sound and effect sound.
MIX
0 – 98, 1.0
Adjusts the mixing ratio of
original sound and effect sound.
29