Oster XPERT Series Instruction Manual page 31

Always place the S blade in the processor bowl before adding ingredients.
WARNING: The blade is very sharp, handle carefully.
4. Place food in the processor bowl. Food to be processed should always be cut into
1-inch (2.5 cm) pieces.
5. Using alignment marks on the lid, place the cover on the processor bowl and press
down firmly while turning counterclockwise to lock.
DO NOT OPERATE UNIT UNLESS COMPLETELY ASSEMBLED
6. Press the power button
( ) will blink, indicating the product is active and ready to use. The light will stay
on when the motor is running.
7. The only food mode available when the food processor accessory is on the motor
base is chop. To select chop, press the food mode button. If opting to use a
manual control instead, low speed is recommended. ALWAYS HOLD THE FOOD
PROCESSOR FIRMLY WITH ONE HAND WHEN STARTING THE UNIT AND
WHEN PROCESSING.
Food can also be chopped or minced by using the technique of fast pulsing. Press
and release the pulse button (
processed in the food processor accessory. Refer to the processing chart on page
15 for proper techniques, quantities and end results.
8. Press the start/pause button (
pause button (
the progress of the blending process and will stop automatically when blending is
complete. Press the power button
9. Press the power button
programmed to turn off automatically if not used for a period of several minutes. All
lights will turn off when the unit automatically powers down.
TO SLICE OR SHRED
10. Place the blade shaft over the post in the processor bowl. Place the slicing/
shredding disk over the blade shaft with the blade of your choice facing up.
WARNING: The blade is very sharp, handle carefully.
11. Using alignment marks on the lid, place the cover on the processor bowl and press
down firmly while turning counterclockwise to lock.
12. Load the feed tube of the cover with ingredients and rest the food pusher in the feed tube.
BLSTTDT Series_BLSTTDG Series_18SEPM1.indd 12
to turn the blender on. The start/pause button
( )
) very quickly to control the size of the food being
) to begin chopping/mincing and press the start/
) to stop when finished. If using chop, the blender will notify about
to cancel the program at any time.
( )
to turn the blender off. This appliance is pre-
( )
E n gl i sh -12
1/17/19 08:52