Operation; Starting Engine; Adjusting Idle Speed; Stopping Engine - Zenoah LRT2300 Owner's/Operator's Manual

Operation

■ STARTING ENGINE

IMPORTANT
1. Rest the unit on a flat, firm place. Keep
the cutting head off the ground and clear of
surrounding objects as it will start rotating
upon starting of the engine.
2.Pump the primer until fuel flows out in the
clear tube.
3.Move the choke lever upward to close the
choke.
4.Shift the ignition switch to the START
position.
5. While pulling the throttle lever with the little
finger of your left hand, pull the starter
rope briskly.
NOTE
Avoid pulling the rope to its end or returning
it by releasing the knob. Such actions can
cause starter failures.
6. When the engine has started, move the
choke lever gradually downward to open
the choke
7. Allow the engine to warm up for a half
minute before starting operation.
NOTE
1. When restarting the engine immediately
after stopping it, leave the choke open.
2. Overchoking can make the engine hard to
start due to excess fuel. When the engine
fails to start after several attempts, open
the choke and repeat pulling the rope, or
remove the spark plug and dry it.

■ STOPPING ENGINE

1. Release the throttle lever and run the
engine for half minute.
2. Shift the ignition switch to the STOP
position.
NOTE
Except for an emergency, avoid stopping the
engine while pulling the throttle lever.
■ ADJUSTING IDLING SPEED
1. When the engine tends to stop frequently
at idling mode, turn the adjusting screw
clockwise.
2. When the cutting blades keep moving after
releasing the trigger, turn the adjusting
screw counter-clockwise.
NOTE
Warm up the engine before adjusting the
idling speed.
11 