Zenoah BCZ2500SU Owner's/Operator's Manual page 14

6. Set up
(BCZ2500SW)
SE5
SE6
SE7
SE8
(1)
(2)
SE9
14
MOUNTING ENGINE (SE5)
1. Push the driveshaft housing toward the clutch
housing and rotate it by hand to check that the
driveshaft is engaged with the gears.
2. Insert the driveshaft housing into the clutch
housing until it bottoms, and align the positioning
holes on the clutch housing and the shaft tube
and install the screw. When difficult to engage,
twist the engine slightly.
3. Fasten the clamp securely with two screws.
IMPORTANT
Tighten the screws gradually by turns.
INSTALLING HANDLE
• Mount the handle to the shaft tube and clamp it
at a location that is comfortable to you. (SE6)
(1) About 14.5 inches (37cm)
CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint
on the top of the carburetor. (SE7)
CONNECTING SWITCH WIRES
• Connect the switch wires between the engine
and the main unit. Pair the wires of the same
color. (SE7)
PUTTING ON WAIST PAD
• Wrap the waist pad around the shaft tube and
the throttle wire. (SE8)
(1) Waist Pad
(2) Band
INSTALLING DEBRIS GUARD
• Put the debris guard on the gear box, attach it
with the 4 screws and hardware provided. (SE9)
(1) Debris guard
(2) Plate
(3) Washer
(4) Screw