Connecting The Telephone; Notes - Gigaset DA611 Manual

Connecting the telephone

Notes

u First use
1. Lift the handset for 5 seconds and place it back in the cradle.
2. Lift the handset again. You will hear the free tone and the device is now ready to be used.
The phone is connected to the power source via the phone line. In case of a power cut (e.g. if the PBX is switched off at night), the above men-
tioned steps need to be repeated. Phonebook entries and speed dialling destinations are stored indefinitely.
u The device is designed to be used as a single-line system (on the main extension or a telephone system).
It cannot be operated as a second phone on a line splitter.
u Operation on a PBX or router
The private branch exchange (PBX) or the router must supply the phone with continuous DC voltage, even when ringing. If this is not the case,
the phone may switch off briefly when ringing. As a result, saved information may be lost. Refer to the operating manual for your PBX or router
for information in this regard or contact the manufacturer.
2
2
1
3
¤
Connect the telephone connector (1) to
the main telephone socket. Use the tele-
phone cable supplied.
You may need a phone adapter depending
on your country.
Power is supplied over the telephone line.
A mains adapters is not necessary.
¤
Guide the cable through the cable
channel (2).
¤
Connect the handset to the telephone
using the coiled cable (3).
el en es it pt