Xerox B205 User Manual page 56

Power Management Settings
The amount of electricity the printer consumes depends on the way it is used. This device is designed
and configured to enable you to reduce your electricity usage.
Power Saver modes are enabled on your device by default to reduce energy consumption. If the printer
is not used for a specified period, it transitions to Low Power mode, then to Very Low Power mode. In
these modes, to enable reduced-power consumption, only essential functions remain active.
Note: Changing the default Power Saver activation times can result in an overall higher energy
consumption of the printer. Before you switch off Power Saver modes or set a longer activation
times, consider the increase in printer power consumption.
You can also enable the printer to power off automatically, either after a specific amount of time, or
when no activity is detected by the printer.
Note: The Auto Power Off feature is not enabled at the factory due to network activity, it is
provided as an option and can be configured at any time. For instructions, refer to
Auto Power Off.
Configuring the Power Saver Mode Settings
1. In Xerox CentreWare
®
2. Click Power Management.
3. Select the Power Saver Mode 1 and Power Save Mode 2 settings required:
• Power Saver Mode 1 Timer: Specify the time the printer remains idle before it goes from
ready mode to Low Power Save mode.
• Power Saver Mode 2 Timer: Specify how long the printer remains in Low Power Save mode
before it goes into Very Low Power Save mode.
Note: The sum of the two timers cannot exceed 119 minutes.
4. Click Apply.
5. Click OK.
Configuring Auto Power Off
1. In Xerox CentreWare
®
Click Power Management.
2.
3. Select the Auto Power Off Timeout settings required:
• Enable: Use this option to enable the printer to power off automatically after the specified
time period. Click Enable, then specify the time the printer remains idle before it powers off
automatically. You can enter between 5 and 240 minutes.
• Disable: Use this option to switch off the Auto Power Off function.
Auto Detect: To set the printer to power off automatically when no activity is detected, click
•
Auto Detect.
4. Click Apply.
Click OK.
5.
Internet Services, click Properties
®
Internet Services, click Properties
®
General Setup.

General Setup.

Xerox B205 Multifunction Printer
®
General Setup
Configuring
54
User Guide