Installing The Qs01 Hdmi Media Streaming - BenQ Home Entertainment Series User Manual

• Avoid leaving the remote control and batteries in an excessive heat or humid environment like the kitchen,
bathroom, sauna, sunroom or in a closed car.
• Replace only with the same or equivalent type recommended by the battery manufacturer.
• Dispose of the used batteries according to the manufacturer's instructions and local environment regulations for
your region.
• Never throw the batteries into a fire. There may be danger of an explosion.
• If the batteries are dead or if you will not be using the remote control for an extended period of time, remove the
batteries to avoid damage to the remote control from possible battery leakage.

Installing the QS01 HDMI Media Streaming

The supplied QS01 HDMI Media Streaming is an Android TV (ATV) dongle to be used with the
projector. See the instructions below to install the dongle. With a successful installation, you can enjoy
more entertainment programs through this projector.
1. Make sure the projector is turned off and
the power cord is disconnected.
3. Plug the USB Micro B cable to the dongle
. Plug the dongle to the HDMI* port on
1
the projector 2
*This HDMI port is for connecting QS01 HDMI
Media Streaming only.
8 Introduction
2
1
1
.
2
1
2. Loosen the screws that secure the top of
projector cover
2 3 .
4. Fit the dongle in place, replace the projector
cover, and tighten the screws.
5. Connect the power cord to the projector and
turn it on. Press
1 . Slide to remove the cover
3
to select HDMI-3 (ATV).