Toro Groundsmaster 200 Series Operator's Manual page 12

10. Loosely install the short hydraulic tube to the straight
fitting on the rear of the lift valve (Fig. 8).
Note: The ends of hydraulic tubes with the tape on them
are to be installed to the lift valve fittings.
11. Loosely install the long hydraulic tube to the elbow
fitting on the bottom of the lift valve (Fig. 8).
12. Mount the manifold block assembly to the manifold
bracket with 2 flange head capscrews (5/16 x 5/8 in.)
(Fig. 9). Torque the screws to 145–190 in.-lb.
(16–21 N m).
2
Figure 9
1. Manifold block
2. Short hydraulic tube
13. Loosely install the other end of the short hydraulic tube
to the elbow fitting on top of the manifold block
(Fig. 9).
14. Loosely install the other end of the long hydraulic tube
to the straight fitting on the front of the manifold block
(Fig. 9).
15. Using the lower set of holes in the right side frame
member, mount the manifold bracket with 2 flange head
capscrews (5/16 x 5/8 in.) and locknuts (Fig. 10).
4
1
3
3. Long hydraulic tube
4. Manifold bracket
Figure 10
16. Tighten the fittings securing both ends of the hydraulic
tubes to the lift valve and manifold block.
17. Tighten the capscrews securing the lift valve to the
frame channel.
18. Mount the hoses to the new tee fitting with the hose
clamps removed, as shown in Figure 11.
1
Figure 11
1. Tee fitting
19. For the Groundsmaster 200 series only, route the
hydraulic hose, previously removed from the elbow
fitting on the bottom of the lift valve, to the rear of the
right front engine mount and connect it to the OUT port
elbow fitting on the side of the manifold block
(Fig. 12).
12