Separating The Cutting Unit From; The Traction Unit - Toro Groundsmaster 200 Series Operator's Manual

Figure 24
Figure 25
2. Position the machine and cutting unit on a level surface
and lower the cutting unit. Remove the dipstick/fill plug
from the top of the gear box (Fig. 26) and make sure
that the lubricant is between the marks on the dipstick.
If the lubricant level is low, add SAE 80–90 wt. gear
lube until the level is between the marks.
Figure 26
1. Fill/check plug
Separating the Cutting Unit
from the Traction Unit
1. Position the machine on level surface, lower the cutting
unit to the floor, move the lift lever to the Float
position, shut the engine off, and engage the parking
brake.
2. Remove the capscrews, flat washers, and locknuts
securing the ball joint mounts to the castor arms on the
cutting unit (Fig. 27).
1
Figure 27
1. Castor arm
20
1
2
2. Ball joint mount