Operation; C/ Additional Functions - Rowenta PROCERAM SO9020F0 Manual

NOT SO9020 CD050131 15/05/06

6- OPERATION

Before switching on your appliance ensure that:
- The appliance is positioned as described in the instructions
- The air intake and outlet grills are completely unobstructed
- The appliance is upright and in a stable position
A/ ON / OFF:
To switch on your appliance:
- First press the ON / OFF switch (F) located at the base of the appliance.
Your appliance is switched on (in the stand by position), the indicator "B" is lit.
- Then press the button on the control panel or the remote control.
Your appliance starts and the display screen lights up.
A beep will be emitted by the appliance every time the command buttons are pressed.
To switch off your appliance:
WARNING: When the appliance is switched off in the heating MODE (AUTO, ECO, 2000W), the ventilation is stopped 30 seconds later in order to eva-
cuate the heat accumulated in the heating element.
- Press the button on the control panel or the remote control.
Your appliance is still powered (in the stand by position), the indicator "B" is still lit.
- To switch the appliance off completely, press the ON / OFF button (F) located at the base of the appliance.
Your appliance stops, the indicator "B" goes out.
B/ THE OPERATING MODES:
Press the button to select the operating mode.
On the control panel: The operating mode indicator selected is lit up.
• MODE:
Press the or buttons on the control panel or the remote control to set the desired temperature.
(between the Frost Free position: 7°C and 35°C); this temperature depends on your preferences.
There is no need to press any other buttons to confirm, this is done automatically.
You can see on the display screen:
- The operating mode as well as the temperature that you have set below the flashing
- After a few seconds disappears, you can then read the room temperature in the
- To view the temperature you have set, simply press the
Note: If the temperature you have set is lower than the room temperature (measured by the appliance) then the appliance will automatically stop. The
the display screen then flashes. The appliance will start heating again automatically as soon as the room temperature drops below the temperature set.
• MODE:
The appliance operates in cold ventilation.
You cannot set the temperature in this operating mode.
You can see on the display screen:
- The " " operating mode and the room temperature.
• MODE:
The appliance operates at a power rating of 1000W and automatically regulates itself so as to avoid exceeding 19°C in the room.
You cannot set the temperature in this operating mode.
You can see on the display screen:
- The " " operating mode and the room temperature.
• MODE:
The appliance operates at a power rating of
You cannot set the temperature in this operating mode
You can see on the display screen:
- The " " operating mode and the room temperature.

C/ ADDITIONAL FUNCTIONS:

• " " AND " " FUNCTIONS:
TIMER: SETTING THE LENGTH OF OPERATION
PROG: SETTING A TIMED START
The programming steps are as follows:
1
Select the Operating mode
4 Confirm the function:
TIMER or PROG
Press the TIMER or PROG buttons
to confirm your choice
10:34 Page 7
or buttons.
(unregulated).
2 Start the function:
TIMER or PROG
Press the TIMER or PROG button
for 2 seconds
3 Define the TIME:
- of the operation for TIMER
- of the later start for PROG
Use the + and – buttons
message.
symbol.
GB
message on