The Digital Displays; Cooking Zone Safety Cut-Out - Zanussi ZKT 650 D Installation And Operating Instructions Manual

The Digital Displays

Digits 1 to 9 and four different letters can appear in
the display.
• The digits show the heat setting selected.
1 = Lowest capacity
9 = Highest capacity
p = Power level
• The following letters and functions are displayed
for the cooking zones:
1
h = Residual Heat Display
Danger! Cooking zone still hot; it extinguishes
when the cooking zone has cooled down. This
display appears only if the cooking zone is
switched off, but the hob is still connected to
the electricity supply.
a = Automatic heating-up (possible for all cook-
ing zones)
is lit, if the cooking zone is set to automatic heating-
up; (remains lit until the automatic feature switches
over to the continued heat setting selected).
_ = Lights up when the automatic switch-off func-
tion has been activated (also see "What to do if ...?").
1
f = Error display
flashes if the cooking zone is activated and
– no pan is on the cooking zone or
– unsuitable pots and pans are used
p = Power function
lights up when the Power function is activated.
The Power function supplies extra-high heating ca-
pacity. It can be activated for the front two cooking
zones.
8
1
Cooking Zone Safety
Cut-out
If one of the cooking zones is not switched off after a
certain time or if the heat setting is not changed, the
corresponding cooking zone switches itself off auto-
matically.
h appears in the ring display for all rings that were
switched on, and _ after they have cooled down.
The rings are switched off at:
• Heat setting 1 - 2
• Heat setting 3 - 4
• Heat setting 5
• Heat setting 6 - 9
3
If one or more cooking zones switch off before
the times indicated see section "What to do
if ...".
Cancelling the Safety Cut-out
To cancel the activated safety cut-out the appliance
must be switched off and then on again using the
ON/OFF sensor field. After this the cooking zones
are again ready for use.
Switching Off for Other Reasons
Liquids that boil over onto the control panel cause all
cooking zones to switch off immediately.
If you place a wet cloth on the control panel it has
the same effect. In both cases the appliance has to
be switched on again using the mains switch
removing the liquid or cloth.
after 6 hours
after 5 hours
after 4 hours
after 1.5 hours
after