Battery Replacement - Fluke i410 Instructions Manual

Battery Replacement

For specified battery life, use an alkaline battery. To replace the battery, see Figure 1.
If the Current Clamp Does Not Work
Battery = OK?
Voltmeter connections?
Voltmeter function/range?
Storage
During long periods of non-use (>60 days), remove and store the battery separately.
Cleaning
Periodically wipe the case with a damp cloth and mild detergent. Do not use
abrasives or solvents.
Service and Parts
The Current Clamp should be serviced only by a qualified service technician. For
service information, contact your nearest Fluke dealer or service center.
Safety Specifications
Maximum voltage between any Terminal
and Earth Ground....................600 V
Temperature
Operating..............................-10 °C to 50 °C
Storage .................................-20 °C to 60 °C
Relative Humidity ....................0 % to 90 % (10 °C to 30 °C)
Operating Altitude ...................2000 m
Storage Altitude ......................12 000 m
Battery Type ............................9 V (alkaline) IEC 6LR61
Battery Life ..............................60 hr typical (continuous with alkaline)
Current x Hz Product ............... ≤240 000
Output Signal...........................1 mV/amp dc or ac
Maximum Conductor
Diameter ...................................1 ea: 30 mm
Figure 1. Battery Replacement
2
Check
0 % to 75 % (30 °C to 40 °C)
0 % to 45 % (40 °C to 50 °C)
2 ea: 25 mm
1
3
Correction
See Battery Test
Red to + or Black to COM
mV dc/mV ac (or V ac)