Warranty - Cadet COM-PAK MAX CM192 Owner's Manual

OPERATING INSTRUCTIONS
1. Make sure all wires are properly
connected and installation is com-
plete before you turn on the heater.
2. Do not operate without grill.
Complete installation
After installation, turn your thermostat to the highest setting and let the heater run for 30 minutes.
Some smoking may occur as the element initially burns off residue from manufacturing.
If your heater shows signs of overheating, such as glowing red or repeatedly getting unusually hot and
shutting off, immediately turn off the circuit breaker and review the "KNOW YOUR VOLTAGE" section
or call us.
If the high-temperature safety shutoff trips more than once a day, replace the heater.
How to operate your heater
The room temperature is controlled by a thermostat located either on the wall, or on the heater. Once
installation is complete and power is on, follow the steps below for your thermostat.
If you have a wall or built-in thermostat with a knob:
1. Turn the thermostat knob all the way to the right.
2. When the room reaches your comfort level, turn the knob to the left, just until it clicks and the
heater turns off. The heater will automatically keep the room temperature around this setting.
3. To reduce the room temperature, turn the knob to the left. To increase the room temperature,
turn the knob to the right.
If you have an electronic wall thermostat, follow the instructions in the programming and operating
guide included with your thermostat.
WITH BUILT-IN THERMOSTAT
D
C MANUAL
RESET
B HIGH TEMP
LIMIT
HEATING ELEMENT
MOTOR
3
OPTIONAL
SINGLE POLE
THERMOSTAT
1
L1 L2
Com-Pak Max Models
CM152T and CM158T
For more effective and safer operation and to prolong the
life of the heater, read the Owner's Guide and follow the
A
INTERRUPTOR
D
LIMITE DE ALTA
C
instructions. Failure to properly maintain the heater will TEMPERATURE
DE REGLAJE
B
void any warranty and may cause the heater to function
ELEMENTO CALENTADOR
improperly.
LIMITED THREE YEAR WARRANTY: Cadet will repair
or replace any Com-Pak Max (CM) heater found to be
MOTOR
3
defective within three years after the date of purchase.
TERMOSTATO OPCIONAL
DE UN SOLO POLO
1
These warranties do not apply:
L1 L2
1. Damage occurs to the product through improper
installation or incorrect supply voltage;
2. Damage occurs to the product through improper
maintenance, misuse, abuse, accident, or alteration;
3. The use of unauthorized accessories or unauthorized
components constitutes an alteration and voids all
warranties. Refer to Cadet website or call customer
service at 855.223.3887 or 360.693.2505 for list of
authorized accessories and components.
To register your product, visit
INTERNAL HEATER WIRING DIAGRAMS
A
D
MANUAL
C
RESET
B HIGH TEMP
LIMIT
HEATING ELEMENT
MOTOR
3
OPTIONAL
SINGLE POLE
THERMOSTAT
1
L1 L2
Com-Pak Max Models
CM192T and CM198T
A
INTERRUPTOR
D
LIMITE DE ALTA
C
TEMPERATURE
DE REGLAJE
B
ELEMENTO CALENTADOR
MOTOR
3
TERMOSTATO OPCIONAL
DE UN SOLO POLO
1
L1 L2
7
3. Do not tamper with the high-
temperature safety shutoff.
WITHOUT THERMOSTAT
D
HEATING ELEMENT
MOTOR
FOR USE WITH
WALL MOUNTED
THERMOSTAT
Com-Pak Max Models
CM152 and CM158

WARRANTY

4. Cadet's warranty is limited to repair or replacement.
5. In the event Cadet elects to replace any part of your
Cadet product, the replacement parts are subject to
the same warranties as the product. The installation
of replacement parts does not modify or extend the
underlying warranties. Replacement or repair of
any Cadet product or part does not create any new
warranties.
If you believe your Cadet product is defective, please
contact Cadet during the warranty period, for instructions
on how to have the repair or replacement processed.
Parts and Service
Visit cadetheat.com/parts-service
where to obtain parts and service.
cadetheat.com/product-registration
D
C
MANUAL
RESET
B
HIGH TEMP
LIMIT
HEATING ELEMENT
MOTOR
FOR USE WITH
WALL MOUNTED
THERMOSTAT
L1 L2
Com-Pak Max Models
CM192 and CM198
for information on
A
C
MANUAL
RESET
B
HIGH TEMP
LIMIT
L1 L2