Table of Contents
Advertisement
11
Securing screws for sealed-beam
unit retaining ring. Loosen se
curing screws, remove retaining
ring and unit. Pull off connector.
12
Securing screws for fog lamp
retaining ring. Loosen securing
screws and take out lamp body.
Pull off plug (13). Disengage
retaining spring and remove
bulb (14).
15
Bulb for turn signal, parking, side
marker and standing lamp.
Loosen fastener (6). Push lamp
body forward and detach. Hold
lamp holder by the wide lug and
8 8 8 2
pull out. Depress bulb, turn to
the left and take out. When
installing the bulb holder, the
lugs must engage the lamp body
recesses. When installing the
lamp body, never fail to engage
the locating webs (16) between
the retaining springs (17).
Tail Lamp Assemblies
1 Turn signal lamp
2 Stop lamp
3 Tail lamp, standing lamp, side
marker lamp
8 8 8 3
Loosen both securing nuts in the
cargo space but do not unscrew
completely. Loosen tail lamp assem
bly by exerting even pressure on both
nuts. Unscrew securing screws com
pletely and detach tail lamp assembly.
Push up the securing lug of the lamp
holder slightly and remove lamp
holder.
To replace, depress bulb, turn it to
the left and pull it out.
Electrical System
(
77
Advertisement
Table of Contents
