Set Temperature; Set Timer(Auto- Off); Set Timer(Auto- On) - Life Smart YAA02E-5 Safety & Operating Instructions Manual

Note: if operated at the Low setting, the heater will not provide as much heat output as in
the High setting , however , the Low setting will not require a much electrical current to
operate .To avoid overloading a circuit , do not plug the heater into a circuit that already
has other appliances working.

SET TEMPERATURE

MODE
F/C
+ -
POWER
1. Press the Mode button until the temperature icon blinks .
2. Use the + and - button to set the desired temperature,from 13 to30℃.
3. The temperature icon will stop blinking and the current room temperature will appear after the
desired temperature is set.
4. The heat will turn-off shortly after the desired temperature is reached and the temperature display
will blink.
5. The heater will turn back on when the room temperature drops below the desired temperature . the
temperature display will then stop blinking and will display the current room temperature.
SET TIMER (AUTO-OFF)
NOTE: This function should only be set if you desire that the heater be automatically
shut off after a certain period of time(1 to 10 hours from the time the function is set)
NOTE: Always set the desired temperature prior to setting the Timer(see step2) so that
the heater will shut off at the desired temperature setting.
6. Press the Mode button until the timer icon blinks. The hour display will appear . The Auto Off icon
will also appear.
+
and - buttons to set the heater operation time between 1 and 10 hours. This function will
7. Use the
activate once the timer icon stops blinking.
8. The heater will automatically turn-off when time runs out.
NOTE :If the desired temperature was set prior to setting the timer function , the heater will cycle on
and off as per the selected desired temperature setting and will discontinue operation once the
programmed timer setting has been reached(default is 10 hours).
SET TIMER (AUTO-ON)
NOTE: This function provides a delayed start option and should only be set if you
desire that the heater be automatically turned ON after a certain period of time (1 to
10 hours from the time the function is set).
NOTE: Always set the desired temperature prior to setting the timer (see step2)so that
the heater will turn on at the desired temperature setting.
1. Press the Mode button until the timer icon blinks. The hour display will appear .The Auto On icon will
also appear.
--SAVE THESE INSTRUCTIONS--
7