Page 1
PORTABLE INFRARED HEATER With Remote Control OWNER’S MANUAL Model No. LS-3ECO WARNING: READ THIS ENTIRE OWNER’S MANUAL CAREFULLY BEFORE USE.
Page 2
Thank you for choosing a Lifesmart Infrared Heater. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new heater.
IMPORTANT SAFETY INSTRUCTIONS READ AND UNDERSTAND ALL INSTRUCTIONS, SAFETY WARNINGS, AND FAQ’s BEFORE USING THE HEATER WARNING! ! POTENTIAL FOR ELECTRICAL HAZARD IF NOT ADHERED TO! When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. This heater must be plugged into a 120V, 15 amp (or more) circuit of its own. Nothing else can be plugged into the same circuit.
Page 4
7. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped, or damaged in any manner. Contact the manufacturer for resolution options. 8. Do not use outdoors. Exposure to outdoor elements such as rain, snow, sun, wind or extreme temperatures may cause the heater to become a safety hazard.
FREQUENTLY ASKED QUESTIONS (FAQ’S) My heater emits a “strange” odor when I first open the box/when I turn the heater on for the first time. Why is this happening? This is normal. This heater is treated with a special heat safe/resistant coating. This odor will sometimes be present when the box is opened, and may be compared to a heaters version of “new car smell.”...
Page 6
many doors/windows, how much bare concrete (acts as a heat sink with any type of heating), the opening and closing of an exterior door, long hallways, high ceilings, etc. Customers with smaller rooms experience quick heat changes. Rooms with larger and open floor plans can expect up to 24 hours to completely heat up.
Page 7
fan should then shut off on its own. In this case, allow a few minutes after the heat cycles off (with power on). The fan will shut off faster when the power is turned off. Why doesn’t the fan speed increase when I change the setting from Low to High? This is normal.
since in the ECO setting, the heater is almost never running on the full 1500 Watts. If this “warm” heat is not plentiful or is “On” constantly, and you fear it will increase your electric bills, we recommend you set it to the High or Low setting and have it cycle off when your set temperature is achieved.
Page 9
IN THE BOX ·INFRARED HEATER ·REMOTE CONTROL (2 AAA batteries not Included) ·INSTRUCTION BOOKLET PRODUCT DIAGRAM Transport Handles Air Outlet (Vent) FRONT VIEW Control Panel Foot pad Remote Control...
Air Intake (Vent) Filter Cover and Mesh REAR VIEW Master Power Switch Temperature Sensor Control Panel 1. Energy-saving mode (ECO) indicator: Will be lit when ECO mode is engaged 2. Low Mode indicator light: Will be lit when Low Heat mode is engaged...
Page 11
3. High Mode indicator light: Will be lit when High Heat mode is engaged 4. Digital display: Indicates set desired room temperature 5. Fahrenheit indicator light: Will be lit when temperature displayed is in Fahrenheit 6. Power indicator light: Indicates that the heater is receiving power from outlet. Will flash when powered “ON’...
PREPARATION Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. Heater to be operated only in upright position with caster wheels attached. Turn on the main power switch in the rear of the unit. Press the On/Off button on the display to power up the heater’s display.
Page 13
Adjust the desired temperature by pressing the Up/Down arrows on the control panel or remote control. Desired temperature options vary from 59℉ to 86℉,or from 15℃ to 30℃. Once you have chosen the desired temperature, the heater will remain on until the room temperature increases to the temperature on the digital display.
Under power-off, press the timer button on the control panel. Digital will indicate time value for the timer. Press the timer button repeatedly, and the value will scroll from 0 to 12 hours (in 1 hour intervals). The light is on when timer (to turn on) is set. 6.
Filter screws Air filter 8. If you will not be using the heater for a while, take the batteries out of the remote control (see steps below) and store for future use. PUSH Battery STORAGE Store the heater in a cool, dry location when not in use. To prevent dust and dirt build-up, use the original packaging to repack the unit.
NOTE: The heater may not be operating if the thermostat is set lower than the room temperature. To begin operation, increase the thermostat temperature for a higher heat setting. Limited Manufacturer Warranty 1 Year Limited Warranty: LIFESMART warrants this heater against defects in materials and workmanship on functional parts, for a period of one year from the original date of purchase.
beyond this manufacturer warranty) that are sold through a retailer or third party, are not directly correlated with this LIFESMART limited warranty, and may be redirected to said retailer or third party for coverage. Extent of Warranty This warranty extends through the manufacturer of the product, and covers functional parts only. Cosmetics are not covered, unless unequivocally determined it is a manufacturer/workmanship defect.
Electrical requirement deficiencies (15-20 Pet/Consumer accidents amp dedicated outlet) Purchases from dealers unauthorized by Use on Extension Cords/Timers/Surge LIFESMART (Authorization in writing) Protectors/GFCI Outdoor applications Normal wear/tear/weathering Disclaimers LIFESMART shall not be liable for any loss due to use (or misuse) of the heater or other LIFESMART products or other incidental or consequential costs, expense or damages without irrefutable foundations.
Page 19
If the answer is not available at that time, you will be referred to the appropriate channels, or given a call/e-mail back within 72 hours with an answer or resolution. *E-Mail is the Preferred Method of Communication LS-3ECO Rev 1 Printed In China...