Operate - Life Smart YAA02E-5 Safety & Operating Instructions Manual

3. Assemble
1. Unpack the Castor Wheels and Arc-shaped Brackets from the product packaging.
2. Turn the radiator upside-down on a scratch-free and stable surface to prevent damage
to the paint finish or your floor surfacing.
3. Fit the two (2) Castor Wheels onto the radiator by placing the Arc-shaped Brackets
between the outermost fins on each side of the radiator.
4. Securely fasten the two (2) Castor Wheels onto the radiator by screwing two (2) Wing
Nuts onto each Foot.
5. Turn the radiator in upright position after the Castor Wheel Assembly fitted. For the
correct upright position, please refer to fig. below
CAUTION: Only operate the radiator in
normal upright position with Castor
Wheel Assemblies attached to the bottom
of the unit (wheels on the bottom, controls
on the top), any other position could create
a hazardous situation

4. Operate

This heater is equipped with Electronic Digital Controls that provide the ability to set the
temperature to the exact degree desired .To operate , simply follow these instructions.
NOTE:The temperature display will not reflect the accurate room temperature until the heater has
been operating for at least 20 minutes.
1. Turn on Power Switch, Press the power button once to start the heater on High
Power( ), Continuous Run. If left at this setting , the unit will run continuously on
High Power and will not shut off until the unit is manually turned off or the room
temperature over 30℃.
2. Press the power button again to change to Lower Power ( ), Continuous Run. If left
at this setting, the unit will run continuously on Lower Power and will not shut off
until the unit is manually turned off or the room temperature over 30℃.
3. Press the power button a third time to turn the heater OFF.
Note:the heater will run continuously if not setting temperature.
--SAVE THESE INSTRUCTIONS--
6