Inspection, Cleaning, And Storage; Inspection Procedure; Specifications - 3M 6500QL Series User Instructions

INSPECTION, CLEANING, AND STORAGE

Failure to follow these instructions may reduce respirator performance, expose you to contaminants above the OEL, and may result in
sickness or death.
• Do not clean respirator with solvents. Cleaning with solvents may degrade some respirator components and reduce respirator
effectiveness.
• Inspect all respirator components before each use to ensure proper operating condition.

Inspection Procedure

This respirator must be inspected before each use and at the time of cleaning to ensure it is in good operating condition. Any damaged or defective parts
must be replaced before use. Do not enter a contaminated area with damaged or defective parts. The following inspection procedure is recommended.
1. Check facepiece for cracks, tears and dirt. Be certain facepiece, especially faceseal area, is not distorted.
2. Examine inhalation valves for signs of distortion, cracking or tearing.
3. Make sure straps are intact and have good elasticity.
4. Examine all plastic parts for signs of cracking or fatiguing. Ensure bayonet gaskets are in good condition.
5. Remove exhalation valve cover (see "Head Harness Assembly & Valve Cover Replacement" procedure) and examine exhalation valve and valve
seat for signs of dirt, distortion, cracking or tearing. Replace exhalation valve cover.
Cleaning and Storage
Cleaning is recommended after each use.
1. Remove cartridges, filters and/or breathing tubes. The exhalation valve cover, exhalation valve and inhalation valves can also be disassembled if
necessary.
2. Clean facepiece (excluding filters and cartridges), by immersing in warm cleaning solution, water temperature not to exceed 120°F (49°C), and
scrub with soft brush until clean. Add neutral detergent if necessary. Do not use cleaners containing lanolin or other oils.
3. Disinfect facepiece by soaking in a solution of quaternary ammonia disinfectant or sodium hypochloride (1oz. [30 mL] household bleach in 2
gallons [7.5 L] of water), or other disinfectant.
4. Rinse in fresh, warm water and air dry in non-contaminated atmosphere.
5. Respirator components must be inspected prior to each use. A respirator with any damaged or deteriorated components should be repaired or
discarded.
6. The cleaned respirator should be stored away from contaminated areas when not in use.

Specifications

Contact 3M Technical Service for technical specifications (e.g. weight, materials of construction, etc). This product contains no components made
from natural rubber latex.
Cartridge and Filter Selection and Approvals
Before using any of these products, the user must read the specific Use For, Use Limitations and Warning information in the cartridge or filter
User Instructions and product documentation or call 3M Technical Service. Do not exceed maximum use concentrations established by local
regulatory agencies.
NIOSH Approvals
Certain Organic Vapors X X
Chlorine
Hydrogen Chloride
Sulfur Dioxide
Chlorine Dioxide
Hydrogen Sulfide
Hydrogen Fluoride
Formaldehyde
Ammonia
Methylamine
Mercury Vapor
Particulate Filter P100
* 3M Recommended for use against methylbromide or radioiodine up to 5ppm with daily cartridge replacement.
NOTE: Not NIOSH approved for use against methylbromide or radioiodine.
3M™ Cartridges, 6000 Series
X X X X X X
X X X X X X
X X X X X
X X X X X X
X X X
X X X X X X
X X
X X
X X
X X
X
X X X X X X X X X
W WARNING
X X X X X
X X X
X X
X X X
X
X X X
X X X
X X
X X
X X
X
7
(English)