Back Panel Connectors - Gigabyte MJ11-EC0 User Manual

1-5

Back Panel Connectors

u
v
Power Button
u
Press the button to turn on/off the system.
ID button with LED
v
When the system identification is active, the ID LED on the front/ back panel glows blue.
RJ-45 LAN Port #1
w
The Gigabit Ethernet LAN port provides Internet connection at up to 1 Gbps data rate. See the section
below for a description of the states of the LAN port LEDs.
RJ-45 LAN Port #2
x
The Gigabit Ethernet LAN port provides Internet connection at up to 1 Gbps data rate. See the section
below for a description of the states of the LAN port LEDs.
10/100/1000 Server Management LAN Port
y
The LAN port provides Internet connection with data transfer speeds of 10/100/1000Mbps. This port is
the dedicated LAN port for Server Management.
USB 3.1 Ports
z
The USB port supports the USB 3.0 specification. Use this port for USB devices such as a USB
keyboard/mouse, USB printer, USB flash drive etc.
VGA Port
{
Connect to a monitor device.
10/100/1000 LAN and ID Button LEDs
Speed LED Link/Activity LED
LAN Port
• When removing the cable connected to a back panel connector, first remove the cable from your
device and then remove it from the motherboard.
• When removing the cable, pull it straight out from the connector. Do not rock it side to side to
prevent an electrical short inside the cable connector.
Hardware Installation
w
x
10/100/1000 LAN Speed LED:
State Description
Yellow On 1 Gbps data rate
Green On 100 Mbps data rate
Off 10 Mbps data rate
- 14 -
y
{
z
ID Button/ LED:
State Description
Blue On System identification is active.
Off System identification is disabled.