Disassembly Sequence; Assembly Sequence; Lubricant And/Or Sealant - Mitsubishi Fuso CANTER FE85DE6SLGP Shop Manual

Disassembly sequence

1 Oil filler cap
2 Grommet
3 Spacer
4 Insulator
5 Cover
6 –
7 Snap ring
8 Fuel return hose
WARNING
• Fuel is highly combustible. Keep fire and heat away.
• Wipe off the leaked fuel. It may cause a fire.
CAUTION
• Be careful not to hit the injectors with a tool or any other hard object during removal.
• Do not allow dust to enter the injectors or injection pipes. Otherwise, faulty injection may result.
• After confirming that no water, oil or any other substance is accumulated in the injector mounting hole, remove the
injector.

Assembly sequence

Follow the disassembly sequence in reverse.
CAUTION
• Be sure to tighten the injector mounting bolts to the specified torque. If they are over-tightened, the injec-
tors may be deformed, resulting in faulty injection.
Tightening torque (Unit: N·m {kgf·m})
Mark
Bolt (cover installation)
Bolt (rocker cover installation)
Bolt (PCV pipe installation)
Injection pipe (union nut installation)
Bolt (injector installation)
Bolt (cylinder sensor installation)

Lubricant and/or sealant

Mark
O-ring
9 Injection pipe
10 Bolt (with hexagonal hole)
11 Injector
12 O-ring
13 Tip gasket
14 PCV pipe
15 –
16 Cylinder sensor
Parts to be tightened
Points of application
17 Rocker cover
18 Rocker cover gasket A
19 Rocker cover gasket B
: Non-reusable parts
PCV: Positive Crankcase Ventilation
Tightening torque
23.2 {2.4}
30.4 to 35 {3.1 to 3.6}
5.2 to 7.2 {0.53 to 0.73}
8 {0.82}
Specified lubricant and/or sealant
Engine oil
11
Remarks
–
–
–
–
Quantity
As required
11-23