Table of Contents
Advertisement
Special tools (Unit: mm)
Mark
Socket wrench
Magnet base
Work before removal
Inspection procedure
Tool name and shape
Inspection: Flywheel friction surface runout
• If the runout exceeds the specified limit, check that the bolts are
tightened correctly and that there are no abnormalities on the
crankshaft mounting surface, then rectify or replace the flywheel.
Inspection: Ring gear
• Check the ring gear of the flywheel by watching and touching. If
there is damage or abnormal wear on it, replace the ring gear
following the procedure below.
[Removal]
• Heat the ring gear evenly with a gas burner or the like until it
reaches approximately 200°C, then remove it from the flywheel
assembly.
WARNING
• Never touch the heated ring gear, otherwise you may burn
yourself.
[Installation]
• Heat the ring gear evenly with a gas burner or the like until it
reaches approximately 200°C.
WARNING
• Never touch the heated ring gear, otherwise you may burn
yourself.
• Fit the ring gear with the side having non-chamfered tooth edges
toward the flywheel.
Part No.
MH062183
Installation of flywheel assembly
MH062356
11
Application
11-65
Advertisement
Table of Contents
Troubleshooting
