Operating Sequence - Zanussi ZT 685 Instruction Booklet

Operating sequence

1. Check the filters
Ensure they are clean and properly positioned
(see cleaning instructions).
2. Check that there is rinse
aid and salt
3. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
Slide the basket back into the machine.
4. Ensure that the spray
arms can rotate freely.
5. Measure out detergent
Add the required amount of detergent into the
dispenser according to the "Washing
programmes" chart and close the lid.
6. Close the detergent
dispenser lid
7. Select the programme
The selection of a programme occurs with the
door partially opened.
Depress the On/Off button; the On/Off
indicator light comes on.
Depress the programme button which
corresponds to the washing programme you
wish to select; the corresponding indicator light
will flash.
8. Start the programme
Close the dishwasher door. An audible signal of
about 1 second advises you that the
programme has started. The indicator light
which corresponds to the programme under
way is now permanently on.
9. At the end of the
washing programme
The dishwasher will automatically stop and an
intermittent audible signal of about 5 seconds
informs you that the programme has finished.
Wait until the end of the signal before opening
the door.
10. Switch off the
dishwasher
Open the door.
The "End of cycle" indicator light flashes.
Depress the On/Off button to switch the
dishwasher off.
11. Cancel the wash
programme
To change a wash programme in progress
depress the button corresponding to the
programme you wish to cancel for about 1
second, until the relevant control light goes out.
The dishwasher is now reset and you can select
a new programme.
In general it is not advisable to open
the door while the machine is
working. If the door is opened
however, a safety device ensures
that the machine stops.
Care must be taken if the door is
opened during the hot phase or
immediately after a programme has
finished, as steam may escape.
When the wash programme has
finished, it is recommended that the
dishwasher is unplugged and the
water tap turned off.
16
POS06UK