The Control Panel - Zanussi ZT 685 Instruction Booklet

The control panel

In this fully integrated appliance the controls are
located on the top of the door. When selecting a
programme, the door needs to be open.
Audible signals have been introduced to help indicate
which operations the dishwasher is performing.
Short signal "instruction accepted"
When any of the buttons are pressed: a short audible
signal informs you that the machine has accepted the
instruction given.
Long signal "programme starting"
A continuous audible signal lasting about one second,
heard only when you close the dishwasher door,
informs you that the washing programme is starting.
Intermittent signal "end of programme"
An intermittent audible signal, lasting for
approximately five seconds, informs you that the
wash programme has finished. If you wish to
deactivate these audible signals, press both the
"NORMAL 65°c" and "BIO 50°c" programme
buttons together for about 3 seconds, until the
intermittent audible signal can no longer be heard.
SO234
To reactivate the audible signals, press both buttons
together again for about 3 seconds, until an
intermittent audible signal is heard.
1 2 3 4
1. On/Off pushbutton
Depress this button to switch the dishwasher on.
The On/Off indicator light illuminates indicating that
the washing programme can be selected and started.
Depress again this button to switch the appliance off.
2. Salt refill indicator light
This illuminates when the salt container needs
refilling. This light will remain on if salt is not added -
for example in a soft water area, where salt is not
required.
3. On/Off indicator light
4. Programme selector
buttons
Depress the button corresponding to the desired
washing programme (see "Washing programmes"
chart).
5. End of cycle indicator
light
This light flashes when the programme has finished.
To switch it off depress the On/Off button.
5
5
PCP11UK