About Dek-Dsp-Rx; Troubleshooting; Restoring The Factory Programmed Settings - Yamaha RIVAGE PM Series Owner's Manual

About DEK-DSP-RX

You can upgrade DSP-RX to DSP-RX-EX by having an
optional DEK-DSP-RX (a DSP expansion kit) installed
and following a few related processes.
Input channel
Bus
Plug-in
Please consult your Yamaha dealer for more information
on the installation and related processes. There are no
parts that you can install by yourself.
16 DSP-RX(-EX) Owner's Manual
DSP-RX DSP-RX-EX
120 288
72 108
384 512

Troubleshooting

Please visit the Yamaha Pro Audio global website for an
FAQ list (Frequently Asked Questions).
http://www.yamahaproaudio.com/
Power does not turn on.
❍ Make sure that the power switches are turned ON.
❍ Make sure that the AC power cords are connected.
➥ If the power still does not turn on, contact your Yamaha
dealer.
The unit is not receiving an audio input signal.
❍ If you are using an optional card, make sure that it is
installed properly.
❍ Make sure that the cables are connected properly.
Restoring the Factory
Programmed Settings
Follow the steps below to initialize the internal memory of
the unit (excluding the Unit ID) to the factory
programmed settings.
NOTE
For more information on setting the Unit ID, refer to "Setting the
Unit ID" in the RIVAGE PM series Operation Manual.
1.
While the unit's power is on, press the
[MENU] key on the front panel.
2.
Use the [U]/[D] keys to select "Initialz."
3.
Press the [ENTER] key.
Press&Hold
[ENTER] to
initialize
4.
Press and hold the [ENTER] key for two
seconds or longer.
The internal memory is initialized and the unit
automatically restarts. After the unit restarts, the
initialization process is complete.
To cancel the initialization process, press the
[MENU], [U] or [D] key, instead of pressing the
[ENTER] key.