Wiring Connections Reliatel Units; Electromechanical Units - Trane BAYECON085A Installer's Manual

Installation
Install the Mixed Air Sensor with grommet, secure with pop-in wire tie. Connect to exiting
jumper connections located in the Indoor Fan Section.
Figure 7.
Figure 8. Mixed Air Sensor for units with Plenum fan (Y/TSC120E(3/4/W), Y/THC092-120E,

Wiring Connections ReliaTel Units

Locate unit wiring harness plug P7 and plug into J7 on the actuator motor.
Note: If Options Module (RTOM) is not installed then connect plug 3P4 to 3J4 on the Refrigeration

Electromechanical Units

Locate unit wiring harness plug PPM2A and plug into the actuator motor wiring harness.
Replace access panels.
8
Mixed Air Sensor figure for units with FC fan (All units except Y/TSC120E(3/4/W), Y/
THC092-120E, WSC120E(3/4/W)
WSC120E(3/4/W)
Module (RTRM) in the control box.
ACC-SVN44D-EN