York YCW SERIES LD11554 Installation & Operation Manual page 12

INSTALL CHECKLIST
Equipment received as ordered.
❑
Unit checked for damage interior and exterior.
❑
Make sure all ductwork is complete and available for full air fl ow.
❑
Unit installed level to ensure proper drain age and operation.
❑
Unit installed with proper clearances.
❑
Ensure con den sate water will drain to ward the drain con nec tion. An overfl ow drain may be required as a back up to a clogged
❑
primary drain.
Check that coil(s), valves and pip ing have been leak checked and in su lat ed as required.
❑
Main coil drain pan must be properly trapped and charged with water before units are started.
❑
Ensure that all air has been vented from the system.
❑
Return valves to their prop er op er at ing po si tions prior to start-up.
❑
Repair any sol der joint leaks and gently tighten any leak ing valve packing nuts and piping ac ces so ries as required.
❑
Install all panels.
❑
CLEANING CHECKLIST
Installer has cleaned out interior.
❑
❑ Ensure drain pan free from foreign ma te ri al.
❑ Ensure air fi lters are clean, installed properly and secured. Use the di rec tion al ar rows or oth er information on the fi lter to
de ter mine the prop er fl ow direction.
CONTROLS CHECKLIST
Check that supply voltage matches nameplate data.
❑
Ensure that the unit is prop er ly ground ed.
❑
Controls installation complete
❑
Check all electrical connections for tightness.
❑
Review electrical print for correct wiring.
❑
FAN INSPECTION -
Check tightness of fan bearing locking collar.
❑
With power off, check blow er wheel set screws for tight ness and ensure that the blower wheel(s) ro tate freely and quietly.
❑
Check tightness of all motor base and mounting bolts.
❑
Check motor connections to en sure that they are se cure and made in accordance with the wiring di a gram
❑
Rotate all moving components manually. Adjust as required.
❑
NOTE: If the motor and fan have not been operated in the last (4) four weeks or more, lubricate all the bearings and rotate the motor and fan
monthly to prevent moisture from accumulating in the bearings. (See Form 50.20-NM3, Long Term Storage)
P.O. Box 1592, York, Pennsylvania USA 17405-1592 P.O. Box 1592, York, Pennsylvania USA 17405-1592
Copyright © by Johnson Controls 2006 Copyright © by Johnson Controls 2006
Form 115.20-NOM6 (1106)
New Release
FAN COILS START-UP CHECKLIST
The fan should be inspected and cleaned, in conjunction with main te nance of the motor and bear ings. It is
im por tant to keep the wheel clean in order to avoid im bal ance and vi bra tion.
Tele. 800-861-1001 Tele. 800-861-1001 Tele. 800-861-1001
www.York.com www.York.com www.York.com
Subject to change without notice. Printed in USA Subject to change without notice. Printed in USA
ALL RIGHTS RESERVED ALL RIGHTS RESERVED