Displayed Messages - DeLonghi ECAM35075 Instructions For Use Manual

18. DISPLAYED MESSAGES

DISPLAYED MESSAGE
Fill tank
Insert tank
Empty grounds container
Insert grounds container
Add pre-ground coffee
Fill beans container
Ground too fine
Adjust grinder
Less coffee
Insert water spout
POSSIBLE CAUSE
Insufficient water in the tank (A17).
The tank (A17) is not correctly in place.
The grounds container (A11) is full.
After cleaning, the grounds container (A11)
has not been replaced.
The "pre-ground coffee" function has been se-
lected without placing any pre-ground coffee
in the funnel (A4).
A LONG coffee with pre-ground coffee has
been requested
The coffee beans have run out.
The pre-ground coffee funnel (A4) is clogged.
The grinding is too fine and the coffee is deliv-
ered too slowly or not at all.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
Too much coffee has been used.
The hot water spout (C6) is not inserted or is
inserted incorrectly.
REMEDY
Fill the tank with water and/or insert it correct-
ly, pushing it as far as it will go until it clicks
into place (fig. 3B).
Insert the tank correctly and press as far as it
will go (page 3B).
Empty the grounds container and drip tray
(A15), clean and replace. Important: when
removing the drip tray, the grounds contain-
er MUST be emptied, even if it contains few
grounds. If this is not done, when you make
the next coffees, the grounds container may fill
up more than expected and clog the machine.
Remove the drip tray (A15) and insert the
grounds container.
Place pre-ground coffee in the funnel (fig. 11)
or deselect the "pre-ground" function.
Put one level measure of pre-ground coffee into
the pre-ground coffee funnel (A4) and press OK
(B3) to continue and complete preparation.
Fill the beans container (A3) (fig. 8).
Empty the funnel with the help of the brush
(C5) as described in section "14.8 Cleaning the
pre-ground coffee funnel".
Repeat coffee delivery and turn the grinding
adjustment dial (A5) (fig. 7) one click clockwise
towards 7 while the coffee grinder is in opera-
tion. If after making at least 2 coffees delivery
is still too slow, repeat the correction procedure,
turning the grinding adjustment dial another
click until delivery is correct (see section "9.1
Adjusting the coffee grinder"r". If the problem
persists, make sure the water tank (A17) is fully
inserted.
Insert the hot water spout (C6) in the appli-
ance and deliver a little water until the flow
becomes regular.
Select a lighter taste by pressing
reduce the quantity of pre-ground coffee.
Fully insert the hot water spout (fig. 4).
21
(B7) or
→