DeLonghi ECAM35075 Instructions For Use Manual page 23

DISPLAYED MESSAGE
Insert milk container
Insert infuser assembly
Water circuit empty
Fill water circuit
Hot water
Confirm?
Press OK to CLEAN
Set dial to CLEAN
ESC to cancel
Turn froth adjustment dial
Descale
ESC to cancel
OK to descale
(∼45 minutes)
Replace filter
ESC to cancel
OK to replace
General alarm
ECO
POSSIBLE CAUSE
The milk container (D) is not inserted correctly. Insert the milk container as far as it will go (fig.
The infuser (A20) has not been replaced after
cleaning.
The water circuit is empty.
The milk container (D) has been inserted with
the froth adjustment dial (D1) in the "CLEAN"
position.
Milk has been delivered recently and the tubes
inside the milk container (D) must be cleaned.
The milk container (D) has been inserted with
the froth adjustment dial (D1) in the "CLEAN"
position.
The machine must be descaled.
The water softener filter (C4) is exhausted.
The inside of the appliance is very dirty.
The tubes inside the milk container (D) must
be cleaned.
The water softener filter (C4) is exhausted and
must be replaced or removed.
The machine must be descaled.
Energy saving is enabled.
REMEDY
18).
Insert the infuser as described in section "14.9
Cleaning the infuser".
Press OK (B3) to deliver water from the spout
(C6) until it flows out normally. If the problem
persists, make sure the water tank (A17) is fully
inserted.
To proceed with the CLEAN function press OK
or turn the froth adjustment dial to another
position.
Turn the froth adjustment dial (D1) to CLEAN
(fig. 19).
Turn the froth adjustment dial to one of the
milk froth positions.
The descaling procedure described in section
"15. Descaling" needs to be performed.
Replace the filter or remove it as described in
section "17. Water softener filter".
Clean the inside of the appliance thoroughly,
as described in section "14. Cleaning". If the
message is still displayed after cleaning, con-
tact a service centre.
Turn the froth adjustment dial (D1) to CLEAN
(fig. 21).
Replace the filter or remove it as described in
section "17. Water softener filter".
The descaling procedure described in section
"15. Descaling" needs to be performed.
The appliance may request descaling cycles at
very short intervals. This is normal and due to
the appliance's advanced control system.
To disable energy saving, proceed as described
in section "7.5 General" - "•
saving:"
22
Energy