Truebrew Over Ice™ Coffee; Making Milk-Based Recipes; Filling And Attaching The Milk Container - DeLonghi ECAM35075 Instructions For Use Manual

Beverages with coffee selectable from the
(B14)
Lungo
Ristretto
Coffee
5. Preparation begins. The beverage selected appears on the
display together with a progress bar which gradually fills
as preparation proceeds.
Important! Making LONG coffee
Halfway through preparation, the message "Add pre-ground
coffee" appears on the display (B1). Add one level measure of
pre-ground coffee and press OK (B3).
Please note:
If "Energy Saving" mode is active, you may have to wait a few
seconds before the first coffee is delivered.
10. TRUEBREW OVER ICE™ COFFEE
1. Add ice to a large glass about half way full (fig. 12), press
the strength selector
(strong or extra strong recommended), and place the glass
under the brewing unit;
12
2. Then, press the
brew the coffee (fig. 13);
3. Add additional ice to the glass/coffee plus any syrup,
sweetener or milk desired and enjoy
Important!
Always use glasses resistant to thermal shock.
Recipe Quantity
≃ 3.38 floz /
100 ml
TrueBrew Over
Ice coffee™ (B9)
≃ 120 ml
≃ 30 ml
≃ 180 ml
:
(B8) to choose a strength
TrueBrew Over Ice™ (B9) button to
Programmable
quantity
from ≃ 1.35 floz/
40 ml to ≃8.11
floz / 240ml

11. MAKING MILK-BASED RECIPES

Please note:
• To avoid milk with poor froth or large bubbles, always
clean the milk container lid (D2) and hot water connection
nozzle (A8) as described in sections "11.4 Cleaning the milk
container after use", "14.10 Cleaning the milk container"
and "14.11 Cleaning the hot water nozzle".

11.1 Filling and attaching the milk container

1. Remove the lid (D2) (fig. 14);
2. Fill the milk container (D3) with a sufficient quantity of
milk, not exceeding the MAX level marked on the handle
(fig. 15). Each mark on the side of the container corre-
sponds to 3.38 fl oz/ 100 ml of milk;
Please note:
• For a denser more even froth, you must use skimmed or
partially skimmed milk at refrigerator temperature (about
41°F/ 4°C).
• If "Energy Saving" mode is enabled, you may have to wait
a few seconds before the first cappuccino is delivered.
3. Make sure the milk intake tube (D4) is correctly inserted in
13
the bottom of the milk container lid (fig. 16);
4. Place the lid back on the milk container;
13
14
16
15
17