Battery Specifications - Powermate ALUMINUM L Series Operating Manual

POWERMATE
dryfit from Sonnenschein.
Solid advantages point-by-point:
• Maintenance-free Needs no maintenance whatsoever throughout its life. Each cell is
and sealed
sealed by a valve preventing penetration by air-borne oxygen. Over-
pressure in the cells [e.g. through over-charging] unseats the valve
so letting out the excess independent pressure; the valve then closes
again. For installations of dryfit batteries in rooms, containers and
cabinets the standards VDE 0510 Part 2 are complied with.
• Independence Sonnenschein dryfit batteries of series A200 can be used in any
of position
orientation including upside down. In stationery installation, care
should be taken to ensure that valves point upwards and are not
covered.
dryfit batteries survive deep-discharging without suffering damage.
• Deep discharge
Even when discharged and remaining connected to a load for 4
resistant
weeks, they recover 80% of their capacity after 48 hours charging.
100% is reached after a few cycles.
• Extremely low
Less than 0.1% of the rated capacity per day at +20C ambient
self-discharging
temperature means no re-charging even after up to 2 years storage.
• Cyclic capability Special measure relating to electrolyte production give A200 version
of dryfit batteries good cyclic capability. At 100% discharge [up to
discharge cut-off voltage of 1.75 Volts/cell] more than 200 cycles can
be obtained. Considerably more cycles are possible with partial
discharges.
• Long-life Under continuous charge operation the life is 4-5 years, end of life
being defined as when 60% of the rated capacity is reached [as per
DIN 43534].
• W ide
From -30C to + 50C [can also be briefly exceeded]. For operation
temperature
under extreme temperature conditions, please observe works
range
recommendations.
• High load Robust grid and connector design gives good high-current load
capacity, all-
properties. Excellently suited for operation under extreme conditions
round use
due to high resistance to vibration. The larger types [from 20Ah] are
suitable for starting internal combustion motors.
• Simple charging Just one charging voltage for cyclic and continuous charging modes.
method
No current limiter needed as charging current is regulated by the
battery. Constant charging voltage at +20C room temperature is 2.3
Volts/cell.
At present 8 types are approved by the VdS [federation of German
• VdS approval:
specialist insurers].
• No hazardous Due to immobilized gel electrolyte dryfit batteries A200 are not
goods
classified as hazardous goods.
PowerMate ®
units are fitted with Sonnenschein Batteries. Customers using
use from a fully charged battery. W hen
®

BATTERY SPECIFICATIONS

PowerMate ®
is not in use, recharge the battery.
6.03
PowerMate
dryfit-the name
that has a
synonym for a
future-oriented
battery generation
PowerMate ®
get a full days'
®
Operation Manual
dryfit technology was invented by
Sonnenschein.
Tested and found to be good!
Sonnenschein dryfit batteries
comply with the following
international standards:
dryfit A 200
DIN 43534 "Maintenance-free"
sealed rechargeable batteries
with gelled electrolyte.
DIN 43539 Part 5 Tests
"Maintenance-free" sealed
rechargeable batteries with
gelled electrolyte.
VdS approvals:
Currently 8 types approved by
VdS [federation of German
insurers].
DIN 57510/VDE 0510
Rechargeable batteries and
battery systems, stationary
batteries.
NATO - Selected types tested
and approved according to
guidelines for military supply
standards.
DIN EN 50014/VDE 0179/0171
Part 1/5.78 General
specifications.
DIN 57833/VDE 0833 Part 1
Danger warning equipment for
fire, assault/robbery and
burglary.
UL recognition File MH 12547.
PN 011700 Rev.E
Eng. 04/ 25/ 14