Yamaha RX-V595 Owner's Manual page 42

Adjusting delay time
You can adjust the time difference between the beginning of the
sound from the main speakers and the beginning of the effect
sound from the rear speakers.
The larger the value, the later the effect sound is generated.
This adjustment can be made to all programs individually.
Program
1.
2.
3.
4.
5.
6.
7.
8.
Adjusting output level of the center, right rear and left rear speakers, and subwoofer
If desired, you can adjust the sound output level of each
speaker even if the output level is already set in "SPEAKER
BALANCE ADJUSTMENT" on pages 24 to 26.
Notes
• Output level of the center speaker cannot be adjusted when
the program DISCO, ROCK CONCERT or CONCERT HALL
is selected, and the input signal is analog, PCM audio, or
encoded with Dolby Digital in 2-channel.
Speakers
CENTER
RIGHT SURROUND (Rear)
LEFT SURROUND (Rear)
SUBWOOFER
Note
The values of the delay time, center/rear/subwoofer output level you set the last time will remain memorized even when this unit is
in the standby mode. However, if the power cord is kept disconnected for more than one week, these values will automatically
change back to the original factory settings.
42
01RX-V595-e/f4
DOLBY PRO LOGIC
DOLBY DIGITAL
DOLBY PRO LOGIC ENHANCED
DOLBY DIGITAL ENHANCED
70 mm MOVIE THEATER
DIGITAL MOVIE THEATER
MONO MOVIE
TV SPORTS
DISCO
ROCK CONCERT
CONCERT HALL
Control range (dB)
MIN, –20 to +10
MIN, –20 to +10
MIN, –20 to +10
MIN, –20 to 0
42
Notes
• Adding too much delay will cause an unnatural effect with
some sources.
• When + or – is pressed, the sound is momentarily inter-
rupted.
Control range (ms) Preset value
15 to 30 20
0 to 15 5
15 to 30 20
0 to 15 5
15 to 30 20
1 to 99 16
1 to 99 49
1 to 99 9
1 to 99 40
1 to 99 16
1 to 99 44
• If the function "1. CNTR" in the SET MENU mode is set to the
NONE position, the sound output level of the center speaker
cannot be adjusted. This is because, in this mode, the center
sound is automatically output from the left and right main
speakers.
• Once the output level is adjusted, the level will be the same
for all digital sound field programs.
Preset value
0
0
0
0
6/23/99, 4:11 PM