Changing The Source Name In The Display Window; Clearing Learned Functions, Macros, Renamed Source Names, And Setup Manufacturer Codes - Yamaha RX-V3200 Owner's Manual

REMOTE CONTROL FEATURES
4
Press MACRO again when
the operation sequence
you want to program is
complete.
Note
• "ERROR" appears in the display window under the following
circumstances:
– when pressing more than one button at once; or
– when MACRO ON/OFF is switched to another position.
Memory back-up
If the remote control is without batteries for more than
3 minutes, or if exhausted batteries remain in the
remote control, the contents of the memory may be
cleared. When the memory is cleared, insert new
batteries, set up the manufacturer code and program
any acquired functions that may have been cleared.
Changing the Source Name in the
Display Window
You can change the name that appears in the display
window on the remote control if you want to use the
different name from the original input selector button
names. This is useful when different component is set in
the input selector button.
1
Press an input selector button, Å or ı to
select the source component you want to
rename.
The selected component name appears in the display
window.
A B
PHONO
V-AUX TUNER MD/TAPE CD-R CD
VCR2/DVR DVD
D-TV/LD CBL/SAT VCR 1
2
Press RE-NAME by using
a ballpoint pen or similar
object.
3
Press k / n to select and enter a character.
Pressing n changes the character in the following
order: A to Z, a to z, 0 to 9, space, - (hyphen) and /
(slash). (Pressing k goes in the reverse order.)
ENTER
4
Press l / h to move the cursor to the next
position.
48
MACRO
RE-NAME
ENTER
y
• If you continuously want to rename another source component,
press ENTER and repeat steps 1, 3 and 4.
5
Press RE-NAME again to exit from the
renaming mode.
RE-NAME
Clearing Learned Functions,
Macros, Renamed Source Names,
and Setup Manufacturer Codes
1 Press an input selector button, Å or ı to
select the source component you want to
clear the function, Macros, names or
manufacturer codes.
The selected component name appears in the display
window.
A B
PHONO
V-AUX TUNER MD/TAPE CD-R CD
VCR2/DVR DVD
D-TV/LD CBL/SAT VCR 1
2
Press CLEAR by using a ballpoint pen or
similar object.
CLEAR
Note
• If you do not press any button within 30 seconds after step 2,
the clearing process is canceled. If this happen, start over from
step 1.