Yamaha RX-V1000 Owner's Manual page 82

TROUBLESHOOTING
Remote control
Problem
The remote control does
not work nor function
properly.
The remote control does
not "learn" new
functions. (The
TRANSMIT indicator
does not light up nor
flash.)
Continuous functions
such as volume
adjustment are learned,
but operate only for a
moment before
stopping.
After this unit has been exposed to a strong external electric shock (such as lightning and strong static electricity) or if
you mishandle the operation of this unit, it may not function properly. In these cases, set this unit in the standby mode,
disconnect the power cord, plug it back in after 30 seconds, and start operating.
78
Cause
Wrong distance or angle.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
The internal microcomputer has
"frozen".
The batteries of this remote control and/or
the other remote control are too weak.
The distance between the two remote
controls is too much or too little.
The signal coding or modulation of the
other remote control is not compatible
with this remote control.
Memory capacity is full.
The internal microcomputer has
"frozen".
The learning process is incomplete.
Remedy
The remote control will function within a
maximum range of 6 m (20 feet) and no
more than 30 degrees off-axis from the front
panel.
Reposition the unit.
Replace all batteries with new ones and press
RESET.
Press RESET on the remote control.
Replace the batteries (and press RESET on
the remote control).
Place the remote controls at the proper
distance.
Learning is not possible.
Further learning is not possible without
deleting unnecessary functions.
Press RESET on the remote control.
Be sure to press and hold the function button
on the other remote control until
TRANSMIT begins flashing slowly.
Refer to
page
8
—
3
3
3
55
55
56, 59, 60
3
56