Impedance Selector Switch; Connecting The Power Supply Cords - Yamaha RX-V1000 Owner's Manual

IMPEDANCE SELECTOR Switch

WARNING
Do not change the IMPEDANCE SELECTOR switch setting while the power of this unit is on, otherwise the unit
may be damaged.
If this unit fails to turn on when STANDBY/ON (or SYSTEM POWER) is pressed, the IMPEDANCE SELECTOR
switch may not be fully slid to either position. If so, slide the switch to either position fully when this unit is in the
standby mode.
Select the left or right position according to the impedance of the speakers in your system. Be sure to move this switch
only when this unit is in the standby mode.
(General model)
VOLTAGE SELECTOR
VOLTAGE SELECTOR
AC OUTLETS
IN
N
SWITCHED
100W MAX. TOTAL
IN
T
IMPEDANCE SELECTOR
SET BEFORE POWER ON
MAIN A OR B: 4 MIN. /SPEAKER MAIN A OR B: 8 MIN. /SPEAKER
A + B: 8 MIN. /SPEAKER A + B:16 MIN. /SPEAKER
CENTER : 6 MIN. /SPEAKER CENTER : 8 MIN. /SPEAKER
REAR : 6 MIN. /SPEAKER REAR : 8 MIN. /SPEAKER
IMPEDANCE SELECTOR
VOLTAGE SELECTOR (China and general models only)
The VOLTAGE SELECTOR on the rear panel of this unit must be set for your local main voltage BEFORE plugging
into the AC main supply. Voltages are 110/120/220/240 V AC, 50/60 Hz.

Connecting the Power Supply Cords

After completing all connections, connect the AC power cord to an AC power outlet. Disconnect the AC power cord if
you will not use this unit for a long period of time.
AC OUTLET(S) (SWITCHED)
VOLTAGE SELECTOR
AC OUTLETS
N
100W MAX. TOTAL
N
T
IMPEDANCE SELECTOR
SET BEFORE POWER ON
MAIN A OR B: 4 MIN. /SPEAKER MAIN A OR B: 8 MIN. /SPEAKER
A + B: 8 MIN. /SPEAKER A + B:16 MIN. /SPEAKER
CENTER : 6 MIN. /SPEAKER CENTER : 8 MIN. /SPEAKER
REAR : 6 MIN. /SPEAKER REAR : 8 MIN. /SPEAKER
SWITCHED
Switch
Speaker
position
Main
Left
Center
Rear
Main
Right
Center
Rear
(General model)
SWITCHED
To AC outlet
Impedance level
If you use one set of main speakers, the impedance of each
speaker must be 4 or higher.
If you use two sets of main speakers, the impedance of
each speaker must be 8
The impedance must be 6
The impedance of each speaker must be 6
If you use one set of main speakers, the impedance of each
speaker must be 8 or higher.
If you use two sets of main speakers, the impedance of
each speaker must be 16
[Canada model only]
The impedance of each speaker must be 8
The impedance must be 8
The impedance of each speaker must be 8
U.S.A., Canada, Singapore, China and
general models .............................................. 2 OUTLETS
Australia model ............................................... 1 OUTLET
Use these outlets to connect the power cords from your
components to this unit. The power to the AC OUTLET(S)
is controlled by this unit's STANDBY/ON (or SYSTEM
POWER and STANDBY). These outlets will supply
power to any connected component whenever this unit is
turned on. The maximum power (total power consumption
of components) that can be connected to the AC
OUTLET(S) is 100 W.
CONNECTIONS
or higher.
or higher.
or higher.
or higher.
or higher.
or higher.
or higher.
19