Setting The Speaker Impedance - Yamaha HTR-5960 Owner's Manual

CONNECTIONS

Setting the speaker impedance

CAUTION
If you are to use 4 or 6 ohm speakers, set "SP
IMP." to "6ΩMIN" as follows BEFORE using this
unit.
2,5
PURE DIRECT
STANDBY
/ON
PRESET/TUNING FM/AM A/B/C/D/E
SEARCH MODE
CATEGORY
OPTIMIZER
EDIT
MIC
PROGRAM
PHONES SPEAKERS
A B STRAIGHT
EFFECT
SILENT CINEMA
2,4 3
1
Make sure this unit is set to the standby
mode.
See page 31 for details about turning on this unit or
setting it to the standby mode.
2
Press and hold STRAIGHT (EFFECT) on the
front panel and then press STANDBY/ON to
turn on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
While holding
STRAIGHT
EFFECT
3
Rotate the PROGRAM selector on the front
panel to select "SP IMP.".
The following display appears in the front panel
display.
S P I M P . - 8 M I N
30
(U.S.A. model)
VOLUME
PRESET/TUNING/CH MEMORY TUNING MODE
DISPLAY
NEXT LEVEL + MAN'L/AUTO FM AUTO/MAN'L
INPUT
VIDEO AUX
TONE CONTROL INPUT MODE MULTI CH
INPUT
S VIDEO VIDEO L AUDIO
down
STANDBY
/ON
PROGRAM
4
Press STRAIGHT (EFFECT) on the front
panel repeatedly to select "6ΩMIN".
The following display appears in the front panel
display.
R OPTICAL
5
Press STANDBY/ON on the front panel to
save the new setting and set this unit to the
standby mode.
Note
The setting you made is reflected next time you turn on this
unit.
STRAIGHT
EFFECT
S P I M P . - 6 M I N
STANDBY
/ON