Yamaha RX-V595aRDS Owner's Manual page 27

TO RECORD A SOURCE ON TAPE, MD OR VIDEO CASSETTE
1
Select the source to be recorded.
Front panel
or
2
Play the source and then turn up the volume to confirm
the input source. (See page 28 for detailed information
on tuning.)
Front panel
or
3
Begin recording on the tape deck, MD recorder or VCR
connected to this unit.
4 1 2
4
Remote control
Notes
• The settings of DSP and VOLUME, BASS, TREBLE and
BALANCE have no effect on the material being recorded.
• Composite video and S video signals pass independently
Remote control
through this unit's video circuits. Therefore, when recording
or dubbing video signals, if your video source unit is con-
nected to provide only an S video (or only a composite video)
signal, you can record only an S video (or only a composite
video) signal on your VCR.
• A source that is connected to this unit only through the digital
terminals cannot be recorded on a tape deck, MD recorder or
VCR connected to this unit.
• A source of signals input to the EXTERNAL DECODER
INPUT terminals of this unit cannot be recorded.
• Please check the copyright laws in your country to record
from records, compact discs, radio, etc. Recording of
copyright material may infringe copyright laws.
If you watch video software that uses scrambled or encoded
signals to prevent it from being dubbed, there may be a case
that the picture itself will be affected by those signals.
1
When a tape deck or MD recorder is being used for
recording, you can monitor the sounds being recorded
by pressing TAPE/MD MON / EXT. DECODER on the
front panel or TAPE/MD on the remote control so that
the "TAPE/MD MON" indicator lights up on the display.
Front panel Remote control
or
4
2
27