Controls And Their Functions - Yamaha RX-V595aRDS Owner's Manual

CONTROLS AND THEIR FUNCTIONS

FRONT PANEL
NATURAL SOUND AV RECEIVER
STANDBY/ON
A / B / C / D / E 1
PHONES SPEAKERS
A B
ON OFF
Refer to pages 44 to 49 for the remote control.
1
STANDBY/ON
Press this switch to turn on the power of this unit. Press it
again to set this unit in the standby mode.
Standby mode
In this state, this unit consumes a very small quantity of
power to receive infrared-signals from the remote control.
2
Remote control sensor
This receives signals from the remote control.
3
Display
This shows various information. (Refer to page 10 for details.)
4
MEMORY (MAN'L/AUTO FM)
Press this button to store the broadcasting stations.
When this button is pressed and held for more than three
seconds, automatic preset tuning begins.
5
EDIT
This button is used to exchange the assigment of two preset
stations with each other.
8
2 3 4 5 6 7
BASS TREBLE
0 0
1 1 1 1
2 2
2 2
3 3 3 3 3
4 4 4 4
5 5 5 5
CINEMA DSP
TAPE/MD MON
/EXT. DECODER
TUNING
8 MEMORY EDIT MODE FM/AM DOWN TUNING
MAN'L/AUTO FM AUTO/MAN'L MONO
BALANCE
RDS TIME/ SET
0 MODE EON
LEVEL MENU
1 1
2
2
3
PTY SEEK
4 4
L 5 5 R
MODE START
6
TUNING MODE (AUTO/MAN'L MONO)
Press this button to switch the tuning mode to automatic or
manual. To select the automatic tuning mode, press this button
so that the "AUTO TUNING" indicator lights up on the display.
To select the manual tuning mode, press this button so that the
"AUTO TUNING" indicator goes off.
7
FM/AM
Press this button to switch the reception band between FM and
AM.
8
TUNING UP/DOWN
This button is used for tuning. Press the UP side to tune in to
higher frequencies, and press the DOWN side to tune in to
lower frequencies.
When this unit is in the PTY SEEK mode, press this button to
change the currently selected program type.
9
TAPE/MD MON / EXT. DECODER
Press this button to play a tape or an MD. The "TAPE/MD
MON" indicator lights up on the display.
When you press the button next, the "TAPE/MD MON" indicator
goes off, "EXT. DECDR" appears on the display and you can
play the signal connected to the EXTERNAL DECODER
INPUT terminals.
0
INPUT
Turn this selector to select the input source (VCR, VIDEO AUX,
TV/DBS, DVD/LD, CD, TUNER, PHONO) that you want to
listen to or watch.
The name of the selected input source appears on the display.
INPUT VOLUME
VCR • V–AUX • TV/DBS • DVD/LD • CD • TUNER • PHONO
18
20
22
40
80
–dB
UP INPUT MODE
EFFECT VIDEO AUX
PROGRAM
8 VIDEO VIDEO L
12
8
4
2
0
AUDIO R