Preset Tuning - Yamaha RX-V1070 Owner's Manual

PRESET TUNING

This unit can store station frequencies (selected by tuning operation) by using preset station buttons. With this function, you can
select any desired station simply by pressing the corresponding preset station button. Up to 40 stations (8 stations per page) can
be programmed.
Illustrations: RX-V1070
Parts in shaded areas (
are not present on RX-V870.
To program stations
1
Tune to the desired station.
(Refer to the previous page for tuning procedures.)
2
Select the desired page (A – E) of preset station
buttons while watching the display.
A/B/C/D/E
3
MEMORY
4
Press a preset station button before "MEMORY" goes
off from the display.
PRESET
Shows the displayed station
has been programmed to A1.
* In the same way, program other stations to A2, A3 ... A8.
* You can program more stations to the preset station buttons on
other pages in the same way by selecting other pages in step 2.
18
)
PRESET
AUTO
FM
STEREO
MHz
0 40
CONCERT
HALL
Flashes for about 5 seconds.
STEREO
AUTO
FM
MHz
0 40 60 80 100
CONCERT
HALL
4, 2 2
(Preset station buttons)
To recall a preset station
1 1
Select the page of preset station buttons.
A/B/C/D/E
2 2
60 80 100
MEMORY
Notes
A new setting can be programmed in place of the former
one.
For presets, the setting of the reception mode (stereo or
monaural) is stored along with the station frequency.
Memory back-up
The memory back-up circuit prevents the programmed data
from being lost even if the POWER switch is turned off or the
power plug is disconnected from the AC outlet or the power is
cut due to temporary power failure. If, however, the power is
cut for more than two weeks, the memory may be erased. If
so, it can be re-programmed simply by following the PRESET
TUNING steps.
2, 1 1
3
PRESET
Select the desired preset station button.
AUTO
FM