Speakers - Yamaha RX-V795RDS Owner's Manual

PREPARATION

Speakers

Use speakers with the specified impedance shown on the rear of this unit.
Center speaker
Right
Main speakers A
How to Connect:
Connect the SPEAKERS terminals to your speakers with the wire of the proper gauge (keep as short as possible). If the
connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct. That is
the + and – markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.
Caution
Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit or the
speakers, or both.
For connecting to the MAIN SPEAKERS terminals
Red: positive (+)
Black: negative (–)
2
1
3
20
Right
CENTER REAR
(SURROUND)
CAUTION
SEE INSTRUCTION MANUAL FOR CORRECT SETTING.
MAIN
A
B
SPEAKERS
Left
Loosen the knob.
Insert the bare wire.
[Remove approx. 5mm
(1/4") insulation from
the speaker wires.]
Tighten the knob and
secure the wire.
Rear speakers
Left
OUTPUT
MAIN CENTER REAR
(SURROUND)
SUB
WOOFER
A
B
Left
For connecting to the REAR and CENTER SPEAKERS
terminals
Red: positive (+)
Black: negative (–)
Subwoofer system
Main speakers B
Right
Press the tab.
Insert the bare wire.
[Remove approx. 5mm
(1/4") insulation from
the speaker wires.]
Release the tab and
secure the wire.